2. Two cabinet securing brackets (D) are suppliedIf required, the dimensions of these pads can be
with the installation pack. They need to bereduced by breaking them where marked.
assembled onto the cabinet prior to cabinet being
pushed into the Kitchen aperture.
1
Left handRight hand
bracketbracket
B
2
- To fit these brackets remove the two screws at the
top left and right hand front corners of the cabinet.
4
- Position the two brackets as shown in the figure
and replace the two securing screws.
4. The joint cover (B) is to be assembled after having
installed the appliance in the recess.
b)
596
555
max
I
+
-
-+
E
3
5
3. Push the appliance into place. The plug socket
necessary for connection of the appliance to the5. Screw appliance into place and retain the cabinet
electricity supply should be positioned, so that thewith screws (I) through the securing brackets into
plug is not placed in the recess.the worktop or adjacent woodwork as necessary.
To adjust the height proceed as follows:
-Loosen or tighten the two front feet.
-The rear feet are adjusted by turning the screw in
the front kick plate to the left or right.
E
II52
If necessary, pads (E) are supplied for the rear feet to
make sliding the appliance in and out of the recess
easier. To fit the pads, press them onto the rear feet.
26 |
ACEC
